The 2016 Mazda MAZDA6 has 1 safety recall on file with NHTSA.
Owners have filed 77 complaints with NHTSA, including 9 crashes, 8 injuries.
The most-reported problem area is Unknown Or Other (11 reports).
2016 Mazda MAZDA6 recalls
Passenger Seat Debris Can Damage Airbag and Steering Wiring
Welding debris left inside the front passenger seat frame during manufacturing can damage the occupant classification system wiring.
Most common 2016 Mazda MAZDA6 problems
Problem areas named in the 77 complaints owners filed with NHTSA.
| Problem area | Reports |
|---|---|
| Unknown Or Other | 11 |
| Electrical System | 11 |
| Power Train | 11 |
| Service Brakes | 11 |
| Seats | 9 |
| Vehicle Speed Control | 7 |
| Engine | 7 |
| Air Bags | 7 |
| Steering | 6 |
| Structure | 5 |
What owners report
The contact owns a 2016 Mazda Mazda6. The contact stated that while driving at an undisclosed speed, a burning odor was noticed inside the vehicle. No warning lights illuminated. The vehicle was taken to an independent mechanic, where it was diagnosed that the clutch disc kit had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure, and a case was filed. The failure mileage was approximately 125,166.
The front CV axles on my car have failed. It begun with a clicking noise and vibration when accelerating. I took the car to the Mazda dealership, and they confirmed the sounds but said they weren't able to diagnose the issue and that I would have to leave my car for them to figure it out. This places my daughter and my life at risk, as well as other passengers, due to the critical role the CV axles play in operating a vehicle. More specifically, the ability to properly control my steering movement while transporting my daughter to and from school is necessary and if not present, very dangerous. An independent service mechanic has confirmed this issue and indicated that this issue has been se
The vehicle exhibits dangerous electronic malfunctions. A licensed technician (MV-113255) has confirmed a sporadic unintended acceleration defect where the cruise control 'decrease' button causes the vehicle to increase speed. Additionally, the vehicle repeatedly enters 'Limp Mode' in active traffic, causing a violent jerk and a total loss of acceleration while displaying a 'Smart City Brake Support' (SCBS) failure on the dashboard. An independent inspection also documented gross mechanical neglect, including loose battery terminals and a loose transmission bellhousing bolt, which may contribute to these intermittent electrical/safety failures.
The contact owns a 2016 Mazda Mazda6. The contact stated that after her husband had driven for approximately 2 hours with the seat heater activated, the passengerâs side seat overheated, and the seat started smoking. The driver stated that the seat heating element overheated and burned a hole in the seat, damaging the air bag located near the seat heater sensor. The dealer was contacted, and an appointment was scheduled. The vehicle was not diagnosed or repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 113,500.
My seat doesnât detect if passanger is in seat so my air bag engine light goes on and off it was recalled and mazda supposedly cleared the issue but seems like they didnt fix it the recall properly
2016 Mazda MAZDA6 questions
Does the 2016 Mazda MAZDA6 have any recalls?
Yes. NHTSA lists 1 safety recall for the 2016 Mazda MAZDA6: Passenger Seat Debris Can Damage Airbag and Steering Wiring. Recall repairs are normally free at an authorized dealer.
What are the most common problems with the 2016 Mazda MAZDA6?
Based on 77 owner complaints filed with NHTSA, the most-reported problem areas are Unknown Or Other (11), Electrical System (11), Power Train (11).
How do I check if a recall on my 2016 Mazda MAZDA6 has been fixed?
Enter your 17-character VIN in our VIN recall check. It shows open recalls that have not been repaired on your specific vehicle. Recall repairs are normally free at an authorized dealer.