The 2014 Kenworth T660 has 11 safety recalls on file with NHTSA.
Owners have filed 1 complaint with NHTSA.
The most-reported problem area is Electronic Stability Control (Esc) (1 report).
2014 Kenworth T660 recalls
Insufficient Air Tank Volume Can Weaken Brakes
Certain Kenworth trucks were built with air tanks that do not hold enough air for the brake system.
ABS warning light may stay off during power loss, raising crash risk
The anti-lock brake system (ABS) controller can lose battery or ignition power.
Hazard lights may stop flashing after braking
On certain Kenworth T440, T470, T660, T680 and T880 trucks, the daytime running lights do not switch off when the hazard warning lights are on.
Driveshaft Weld Can Fail and Cut Power to Rear Wheels
A driveshaft weld on these heavy trucks can fail because of corrosion.
Alternator cable can chafe and cause a fire
The alternator charge cable on these trucks may rub against a metal freon discharge line.
Water Can Disable Wipers and Cause Electrical Fire
Water can leak into the windshield wiper motor on certain heavy trucks built between November 2010 and April 2015.
Most common 2014 Kenworth T660 problems
Problem areas named in the 1 complaints owners filed with NHTSA.
| Problem area | Reports |
|---|---|
| Electronic Stability Control (Esc) | 1 |
| Service Brakes, Air | 1 |
What owners report
The contact owns a 2014 Kenworth T660. The contact received a recall notification for NHTSA Campaign Number: 20V199000 (Electronic Stability Control, Service Brakes, Air). The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was notified of the issue. The part was not available for repair. The contact had not experienced a failure. Parts distribution disconnect.
2014 Kenworth T660 questions
Does the 2014 Kenworth T660 have any recalls?
Yes. NHTSA lists 11 safety recalls for the 2014 Kenworth T660: Insufficient Air Tank Volume Can Weaken Brakes; ABS warning light may stay off during power loss, raising crash risk; Hazard lights may stop flashing after braking; Driveshaft Weld Can Fail and Cut Power to Rear Wheels; Alternator cable can chafe and cause a fire. Recall repairs are normally free at an authorized dealer.
What are the most common problems with the 2014 Kenworth T660?
Based on 1 owner complaint filed with NHTSA, the most-reported problem areas are Electronic Stability Control (Esc) (1), Service Brakes, Air (1).
How do I check if a recall on my 2014 Kenworth T660 has been fixed?
Enter your 17-character VIN in our VIN recall check. It shows open recalls that have not been repaired on your specific vehicle. Recall repairs are normally free at an authorized dealer.