2013 Victory Vision Recalls, Problems & Safety Rating

2013 Victory Vision recalls

Most common 2013 Victory Vision problems

Problem areas named in the 9 complaints owners filed with NHTSA.

Problem area	Reports
Structure	6
Steering	3
Engine	2
Wheels	1
Service Brakes	1

What owners report

2019-07-12, Service Brakes
THE REAR BRAKE MASTER CYLINDER HAS NEEDED TO BE REPLACED TWICE IN THE 5 YEARS THAT I HAVE OWNED THIS MOTORCYCLE. EACH TIME IT FAILED IT CAUSED A LOSS IN THE ABILITY TO STOP THE BIKE WHILE RIDING. I HAVE BEEN TOLD BY THE DEALERSHIP THAT I PURCHASED THE BIKE FROM THAT THIS IS A COMMON PROBLEM WITH MANY VICTORY BRAND MOTORCYCLES. I HAVE BEEN TOLD BY THE SERVICE MANAGER AT MY DEALERSHIP THAT THE PART CAN'T BE REPAIRED BUT MUST BE REPLACED, BUT THE REPLACEMENT PARTS, WHILE THEY WORK AS THEY SHOULD, ARE NO BETTER THAN THE ORIGINAL PARTS AND THERE IS NO GUARANTEE THAT THE SAME PROBLEM WILL NOT OCCUR AGAIN IN THE FUTURE.

2015-06-09, Structure
THE VICTORY VISION HAS A TWO PIECE PLASTIC FRONT FENDER WHICH IS HELD TOGETHER WITH PLASTIC FASTENERS AND MOUNTED DIRECTLY TO THE METAL FORKS WITH METAL SCREWS. VIBRATIONS FRACTURED THE REAR PORTION OF THE PLASTIC FENDER AT THE POINT WHERE IT CONTACTS THE METAL FORKS, THIS CAUSED THE REAR PORTION OF THE FENDER TO FAIL, DISLODGE ITSELF AND BECOME WEDGED BETWEEN THE FORKS AND THE MAIN BODY OF THE MOTORCYCLE AFFECTING STEERING. FORTUNATELY THE SPEED WAS LOW AND THERE WAS NO ACCIDENT, HOWEVER, IF THIS INCIDENT HAD OCCURRED AT HIGHWAY SPEED OR DURING CORNERING THE RESULT COULD HAVE BEEN FATAL. PLEASE CONSIDER ADDRESSING THIS ISSUE WITH THE MANUFACTURE AS I HAVE AND THEY REFUSE TO ACCEPT RESPONSIB

2014-12-12, Engine
WHILE SLOWING THE MOTORCYCLE NORMALLY IN PREPARATION FOR STOPPING AT A STOP LIGHT IN HEAVY TRAFFIC AND REV-MATCHING THE ENGINE NORMALLY, THE ENGINE STALLED REQUIRING EVASIVE ACTION TO AVOID COLLISION WITH OTHER VEHICLES AND BRING THE MOTORCYCLE TO A SAFE STOP. THE ENGINE WOULD NOT RESTART IMMEDIATELY AND REQUIRED 3 ATTEMPTS TO RESTART. THIS HAS HAPPENED ON NO LESS THAN FOUR OCCASIONS. MANUFACTURER SAYS THE MOTORCYCLE ENGINE IS DESIGNED TO STALL IN THIS MANNER. THE TIMING AND ELECTRONIC FUEL INJECTION (EFI) ARE PURPOSELY DESIGNED TO MALFUNCTION AND READ REV-MATCHING ON DOWNSHIFT AS OVER SUPPLYING FUEL AND SHUTTING THE ENGINE OFF TO "AVOID DAMAGE". NOTE THAT IN EVERY INSTANCE OF THIS HAPPENI

2014-10-28, Structure
ON ROUTINE INSPECTION FOUND A 1 TO 2 INCH CRACK IN THE PLASTIC PORTION OF THE FRONT FENDER. I HAVE BEEN WATCHING FOR THIS PROBLEM AFTER READING DIFFERENT VICTORY INTERNET SITES. THIS PROBLEM HAS THE POTENTIAL TO LOCK UP THE FRONT WHEEL. *TR

2014-10-14, Structure
2013 VICTORY VISION. THE FRONT REAR SECTION OF THE FENDER (PLASTIC) CRACKS WHERE IT ATTACHES TO THE FRONT FORKS. THIS IS A WIDELY KNOWN ISSUE THAT HAS HAPPENED TO 100;S IF NOT 1,000S OF VICTORY VISIONS. POLARIS REFUSES TO REPAIR OR REPLACE, AND SUGGESTS THAT IT IS NORMAL WEAR AND TEAR. THIS IS A HUGE SAFELY ISSUE THAT MUST BE INVESTIGATED. *TR

2013 Victory Vision questions

Does the 2013 Victory Vision have any recalls?

Yes. NHTSA lists 1 safety recall for the 2013 Victory Vision: Equipment. Recall repairs are normally free at an authorized dealer.

What are the most common problems with the 2013 Victory Vision?

Based on 9 owner complaints filed with NHTSA, the most-reported problem areas are Structure (6), Steering (3), Engine (2).

How do I check if a recall on my 2013 Victory Vision has been fixed?

Enter your 17-character VIN in our VIN recall check. It shows open recalls that have not been repaired on your specific vehicle. Recall repairs are normally free at an authorized dealer.