CarRecallWatch- Component
- POWER TRAIN:DRIVELINE:DRIVESHAFT
- Problem
- Chrysler (FCA US LLC) is recalling certain 2020 Jeep Gladiator vehicles. The rear driveshafts may have been incorrectly assembled without grease in the monoblock joint.
- Risk
- A joint without grease may overheat and seize, possibly causing the driveshaft to fracture, resulting in a sudden loss of drive power. If the driveshaft completely separates from the vehicle it may become a road hazard. Either of these scenarios can increase the risk of a crash.
- Remedy
- FCA US will notify owners, and dealers will replace the driveshaft, free of charge. The recall began October 10, 2019. Owners may contact FCA US customer service at 1-800-853-1403. FCA US number for this recall is V95.
- Notes
- Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
What this recall means for you
The rear driveshafts on certain vehicles may have been assembled without grease in the monoblock joint. Without lubrication, the joint can overheat and seize, which may cause the driveshaft to fracture and lead to a sudden loss of drive power. If the driveshaft separates completely from the vehicle, it can become a road hazard. Either situation increases the risk of a crash.
The repair is free. FCA US will notify owners, and authorized dealers will replace the driveshaft at no charge. You can contact FCA US customer service at 1-800-853-1403, referencing recall number V95. You can also check your vehicle identification number (VIN) for open recalls to confirm whether your vehicle is affected.
Check whether this recall is open on your vehicle
Official recall notice
Affected vehicles
| Jeep Gladiator | 2020 |
|---|