CarRecallWatch- Component
- STEERING; STEERING:LINKAGES:TIE ROD ASSEMBLY
- Problem
- E-One Incorporated (E-One) is recalling certain 2015 Cyclone II and Quest II emergency vehicles, equipped with certain Spicer D-Series and E-Series steer axles. The castellated nut on the steer axles may not be properly torqued, allowing the tie rod to loosen.
- Risk
- If the tie rod loosens, it may disconnect from the steering knuckle, causing a complete loss of steering and increasing the risk of a crash.
- Remedy
- E-One will notify owners, and dealers will inspect the torque of the castellated nut and tie rod, tightening it as necessary. If the tie rod stud and knuckle on units cannot be sufficiently torqued, the dealer will replace the knuckle and tie rod end assembly, free of charge. The recall began on October 5, 2017. Owners may contact E-One customer service at 1-800-627-5050.
- Notes
- Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
What this recall means for you
A castellated nut on the steer axle may not be properly torqued, which can allow the tie rod to loosen. If the tie rod loosens, it may disconnect from the steering knuckle, causing a complete loss of steering and increasing the risk of a crash.
Dealers will inspect the torque of the castellated nut and tie rod and tighten them as necessary. If the tie rod stud and knuckle cannot be sufficiently torqued, the dealer will replace the knuckle and tie rod end assembly. The repair is free of charge at an authorized dealer. You can also contact E-One customer service at 1-800-627-5050, and check your VIN for any open recalls.
Check whether this recall is open on your vehicle
Official recall notice
Affected vehicles
| E-One Cyclone II | 2015 |
|---|---|
| E-One Quest II | 2015 |