CarRecallWatchThe 2018 Mazda MAZDA3 has 4 safety recalls on file with NHTSA.
Owners have filed 110 complaints with NHTSA, including 6 crashes, 5 injuries.
The most-reported problem area is Electrical System (30 reports).
2018 Mazda MAZDA3 recalls
Rearview camera may flicker or distort, reducing rear view
The rearview camera image may flicker or appear distorted on the display screen.
Fuel Pump Can Fail and Stall the Engine
The low-pressure fuel pump inside these vehicles may have an impeller that cracks and deforms.
Windshield Wipers May Stop Working, Reducing Visibility
A defective windshield wiper relay can cause the windshield wipers to become inoperative, reducing the driver's view of the road.
Exhaust valve spring may fail, causing engine stall
Certain 2018 Mazda3 vehicles may have an incorrect exhaust valve spring.
Most common 2018 Mazda MAZDA3 problems
Problem areas named in the 110 complaints owners filed with NHTSA.
| Problem area | Reports |
|---|---|
| Electrical System | 30 |
| Unknown Or Other | 26 |
| Visibility/Wiper | 16 |
| Back Over Prevention | 16 |
| Engine | 12 |
| Fuel/Propulsion System | 7 |
| Service Brakes | 6 |
| Power Train | 5 |
| Forward Collision Avoidance | 5 |
| Fuel System, Gasoline | 4 |
What owners report
The contact owns a 2018 Mazda Mazda3. The contact stated that while reversing, the rearview camera displayed a distorted image, nearly resulting in a collision with a parked vehicle. Several unknown warning lights illuminated, creating a driver distraction. In addition, the infotainment screen delaminated and experienced ghost touching with random phantom touches. The vehicle was taken to the dealer, where it was determined that the infotainment system required a new lens kit. The vehicle was not repaired. The manufacturer was notified of the failure by telephone, and a case was filed. The failure mileage was unknown.
The contact owns a 2018 Mazda Mazda3. The contact stated that while driving uphill at 45 MPH, the vehicle sputtered, hesitated to accelerate, and the check engine warning light illuminated. When the contact firmly depressed the accelerator pedal, the engine made a knocking noise, and the vehicle stalled. Diagnostic testing at AutoZone retrieved DTC related to the knock sensor. The vehicle underwent a tune-up, and the knock sensors and ignition coils were replaced; however, the failure persisted. While driving, the vehicle hesitated and failed to exceed 40 MPH. The contact pulled over, restarted the vehicle, and drove to the residence with the hazard lights activated. The vehicle was taken to
The sunroof spontaneously shattered while I was driving. It sounded like a small explosion. I am positive that no object struck the vehicle.
The contact called on behalf of a customer who owns a 2018 Mazda Mazda3. The contact stated that the windshield wipers had become inoperable. The vehicle was taken to the contact's auto repair shop, Tire-Rama, where the windshield wiper switch was replaced; however, the failure persisted. Upon investigation, the contact associated the failure with NHTSA Campaign Number: 19V272000 (VISIBILITY); and referred the customer to the dealer for assistance. The vehicle was taken to the dealer, who informed the owner that the vehicle was not covered under the recall because the VIN was not included. The manufacturer was not notified of the failure. The failure mileage was approximately 200,000.
While I was driving on the highway, I went to use my front wipers and there was no response when trying to active them. The rear wiper, front and rear washer fluid sprayers all worked. No warning lights or other signs of failure were present. I took the car to a local repair shop and they diagnosed it as a bad Body Control Module. Once the module was replaced and reprogrammed, the wipers worked as intended. Safety Recall 3219D describes the issue I had perfecly. My VIN is out of the range of this recall but if I had the same issue as this recall, there might be other bad parts out there and that range might need to be increased.
2018 Mazda MAZDA3 questions
Does the 2018 Mazda MAZDA3 have any recalls?
Yes. NHTSA lists 4 safety recalls for the 2018 Mazda MAZDA3: Rearview camera may flicker or distort, reducing rear view; Fuel Pump Can Fail and Stall the Engine; Windshield Wipers May Stop Working, Reducing Visibility; Exhaust valve spring may fail, causing engine stall. Recall repairs are normally free at an authorized dealer.
What are the most common problems with the 2018 Mazda MAZDA3?
Based on 110 owner complaints filed with NHTSA, the most-reported problem areas are Electrical System (30), Unknown Or Other (26), Visibility/Wiper (16).
How do I check if a recall on my 2018 Mazda MAZDA3 has been fixed?
Enter your 17-character VIN in our VIN recall check. It shows open recalls that have not been repaired on your specific vehicle. Recall repairs are normally free at an authorized dealer.